Follow

System status descriptions

The table below shows the description of each status shown in LifeHub. 

STATUS

DESCRIPTION

System Online

This is showing that the operator is using the SmartCap properly and fatigue levels are being recorded. The fatigue level is not shown here to ensure operator privacy, however fatigue alarms for this operator will still be triggered if appropriate.

Fatigue Level *

 

(* levels shown are 2, 3, 3+ and 4)

This will only be seen by certain LifeHub users to ensure operator privacy. It shows the currently displayed fatigue level of the operator. Information about fatigue levels is provided on page 37 of this User Guide.

Plant on less than 10 mins

The plant (e.g. truck, dozer, etc.) has recently been started by an operator.

No Cap Connected

The truck ignition is “on” however no Bluetooth connection has yet been made from the LifeBand to the LifeDisplay, i.e. the operator is not using the SmartCap system.

Cap Off

The operator in the truck is not wearing the SmartCap. A Bluetooth connection has been established, but it has not been able to calculate a fatigue level.

On some occasions, this message may appear when a poorly fitted SmartCap is being worn by an operator, which requires replacement.

Poorly Fitted Cap

The operator in the truck is wearing the LifeBand; however the system is indicating that the cap may need adjustment.

Offline

LifeHub has a communications link established with the truck; however the truck has been shut down by the operator. This may be for crib breaks, shift changeover, maintenance or some other deliberate reason.

No Comms

LifeHub has no communications link established with the truck. This is most likely a result of the truck entering areas of poor reception onsite or because of equipment failure.

Unassigned

If a plant is “unassigned”, the combination of SmartCap hardware has not yet been given a name. This can occur if some hardware is replaced. The assignment process can be performed by clicking on the word “unassigned”.

If a piece of headwear is being used that has not been assigned to a specific operator, this will also show up as “unassigned”. The assignment process can be performed by clicking the word “unassigned”.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Copyright © 2014-2015 · All Rights Reserved · SmartCap Technologies Pty Ltd